塑膠控制板－汽車車門用配件

控制板在汽車車門塑膠零配件屬於安全部品(安全零件)，必需在任何情況下盡可能維持汽車車門可開啟狀態。塑膠汽車零件需在氣候溫度零下４０度至８０度時，不能影響其功能性。射出代工此汽車零配件的尺寸要求非常精密，此外，射出成形時，也需在有限的公差內掌控好輪廓平行度（滑軌輪廓），平面度，垂直度，同心度，再搭配本廠2.5次元影像量測儀量測。塑膠產品有特殊物性要求，選用高階ＰＯＭ塑膠材質。

*此為代工產品，僅供精密塑膠射出介紹*

Product：Original Auto Parts ---Door Control Panel Plastic Parts

Material：POM

Size：According to customer requirements

Introduction：

Plastic Control Panel - Parts for Auto Doors

The control panel in the car door are safety parts, and the doors must be able to open as much as possible at any circumstances.

In the climate temperature is minus 40 degrees to 80 degrees, plastic auto parts should not affect their functionality

The size requirements of this auto parts are very precise.

Injection molding, it is also necessary to control the contour parallelism (slide rail contour), flatness, verticality, concentricity within a limited tolerance, and then match the 2.5D vision measuring system measuring instrument measurement.

Plastic products has special physical property requirements, and high-end POM plastic materials are selected

*This is an OEM product, only for the introduction of plastic injection *